Wednesday, November 2, 2022

You're Weird - Light up card with Chibitronic LED Stickers

  Hi Everyone,

For today's card I have used a stamp set from Heffy Doodle and LED Stickers from Chibitronics.

For this card I have used the new 'Craft with light kit'.  It makes craft with Chibitronics so much easier as everything you need is in one pack.


Ingredients

Stamp Set:  You're Weird

Medium:  Copic Markers

Electronics:  Craft with Light kit from Chibitronics

Background:  Distress Inks & Amsterdam White Ink

(Twisted Citron, Salty Ocean, Blueprint Sketch, Faded Jeans, Black Soot)

Card Stock:  X-Press It Blending Card

Ink:  MFT Extreme Black

Other:  White Gelly Roll 08 Pen, Shimmer Pen, Glossy Accents


Method

1. Background

Firstly, I stamped the images onto X-Press It Blending Card and coloured them with Copic Markers.  I have then cut them out using the coordinating dies.

The background has been created using distress inks (listed above) and Amsterdam ink.



2. Battery Holder

This card will measure 14 x 10cm once complete.

I have used the Silhouette Cameo to cut the layers for the battery holder.  I glued 7 of these together.

I have glued them together using Liquid Glue from Bearly Arts.  If find this glue does not warp the card and makes it really strong.

I put plain card stock on the back of this card to finish this card.

The card used is 300gsm smooth white card,


3. Circuit

The circuit has been designed on the battery holder.

I have marked where the light will go (from the card front).  I then mapped where I want the circuit to go in pencil.  This makes it easier for me to complete the circuit.



4.  Completing the Circuit

The Circuit has been complete using the Fabric Conductive Tape and LED Stickers.

This card works by pressing the bottom right hand corner (over the battery).  The positive will connect with the battery, turning on the lights.



5. Adhere the card front

It is time to adhere the card front I prepared earlier to the battery compartment.

I have used double sided tape to do this.

The coloured image have been adhered using foam tape.



6. Let's light this card up!

This circuit uses a 2016 battery to power this card.

To light this card card up, press the bottom right hand corner as shown.





I hope I have inspired you to give Chibitronics LED Stickers a go.
If you have any questions, please don't hesitate to ask.


Until next time
Melissa
xxxxx

No comments:

Post a Comment